MIL-S-1419D (PA)
3.5 Functioning (Proving Ground). - The signals shall func-
tion in accordance with the following requirements:
3.5.1 No star shall burst in the pistol.
3.5.2 The signal case shall not split, rupture, or bulge
to the extent that it sticks or "freezes" in the pistol barrel.
3.5.3 The primer shall not fail to function.
3.5.4 The star shall not fail to attain a minimum (min.)
altitude of 150 feet above the firing point.
3.5.5 The star shall not fail to Ignite and reach approxi-
mately 1/4 of full brilliance within 2 seconds after firing.
3.5.6 Portions of composition that become detached during
star burning shall not bum for more than two seconds.
3.6 Air leakage test. - The signal shall show no evidence
of leakage.
3.7 workmanship. - All parts shall be fabricated and
loaded in a through workmanlike manner, and all manufacturing,
processing, and assembly operations shall be correctly performed.
They shall be clean and free of burrs, sharp edges, unblended
radii, surface defects, chips, dirt, grease and oil (except
where specifically required) corrosion products and other for-
eign matter. The cleaning method used shall not be injurious
to any part nor shall the parts be contaminated by the clean-
ing agent. Exterior surface coatings shall be continuous except
for a few light scratches not exposing base material. All re-
quired markings shall be neat and sharply defined. (All pack-
ing components shall be dry).
3.8 First Article Inspection. - This specification contains
technical provisions for first article inspection. Requirements
for the submission of first article samples by the contractor shall
be as specified In the contract.
4.
QUALITY ASSURANCE PROVISIONS
4.1 Responsibility for Inspection.-Unless otherwise
specified in the contract or purchase order, the supplier is
responsible for the performance of all inspection requirements
4
For Parts Inquires call Parts Hangar, Inc (727) 493-0744
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business