MIL-S-63523 Simulator, Launching, Anti-Tank, Guided Missile And Rocket, M22, Performance SpecificationThis specification covers requirements for design and establishes a uniform method of testing one type of Simulator, Launching, Anti-Tank, Guided Missile and Rocket, M22. The purpose of the M22 Simulator testing program is to determine performance, safety, soundness of mechanical design and resistance to environments encountered during storage, handling, and service use.

Pages 1 - 2 - 3 - 4 - 5 - 6 - 7 - 8 - 9 - 10

MIL-S-63523A(AR)

(The Interstate Commerce Commission Regulations are now part of the

code of federal regulations (1967) editions and revisions) available

from the superintendent of documents, Government Printing Office,

Washington, DC 20315. Orders for the above publications, cite

49CFR-100-199 (Latest Revision).

2.2 Order of precedence. In the event of a conflict between

the text of this specification and the references cited herein, the

test of this specification shall take precedence.

REQUIREMENTS

3.1 Engineering design test.

This specification makes

provisions for engineering design testing.

3.2 Assembly. The simulator assembly shall comply with all

requirements specified in Dwg. 11749630 and all associated drawings,

and with all requirements specified in applicable specifications and

standards.

3.3 Design and construction. The components of the simulator

shall be designed and constructed to conform to the performance

requirements specified herein.

3.3.1 Assembly of components. The components of the simulator

shall consist of a Case and Closure Switch in accordance with Dwg.

11749630.

3.3.2 Contact closure switch. The output end of the cartridge

shall contain an electrical contact strip (contact closure switch,

refer to part no. 11749641) . This strip shall have less than 1 ohm

resistance when measured as specified in 4.5.4.

3.3.3 Static and other electric hazard. The ignition system

shall be designed and maintained so that the static charges and

induced electric energies will not produce a hazardous device.

3.4 Firing device.

3.4.1 Performance characteristics. The simulator shall not

damage the firing device (Figure 1) or interfere with repeated use.

Moisture content.

3.4.2

3.4.2.1 Charge composition. The moisture content of the charge

composition at the loading station at the time of loading shall not

exceed 0.10 percent, when measured as specified in para. 4.5.2.1.

3.4.2.2 Paper and paper products. The moisture content of the

paper and paper products components of the simulator assembly at the

loading station at the time of loading shall not exceed 6.0 percent

when measured as specified in para. 4.5.2.2.