MIL-DTL-83352D
3.8.3.2 High temperature storage. The signal shall function as specified in 3.5.1, except for the
display burn time and apogee altitude as listed in table I, when it has been stored at 160 ±5°F for
28 days.
3.8.3.3 Low temperature storage. The signal shall function as specified in 3.5.1, except for the
display burn time and apogee altitude as listed in table I, when it has been stored at -65 ±5°F for
28 days.
3.8.4 Vibration. The signal kit shall withstand a vibration of 10 to 60 Hz, with amplitude
maintained at 0.10 ±0.01 in. double amplitude up to and including 20 Hz and at 2 ±0.2g peak for
the remaining frequency coverage. The signal kit shall then function as specified in 3.5.1.
4.
VERIFICATION
Classification of inspections. The inspection requirements specified herein are classified
4.1
as follows:
a.
First article inspection (see 4.2).
b.
Conformance inspection (see 4.3).
First article inspection. First article inspection shall be performed on signal kits
4.2
representative of the production units to be supplied by the vendor. The first article tests shall
include the tests and quantities specified in table II.
4.3
Conformance inspection. Conformance inspection shall include the visual examination
in 4.6.1 and the sample tests in 4.3.1. Lot size shall be a maximum of 5,000 kits (35,000
signals). Samples required for test purposes may be in addition to the deliverable units.
4.3.1 Sample tests. The conformance sample plan shall include the examinations, tests and
quantities specified in table III.
4.4
Test conditions. Unless otherwise specified, all inspections shall be performed in
accordance with the test conditions specified in the applicable test method documents or
applicable paragraphs in this specification. Suggestions for certain test procedures are provided
in section 6.4.
4.5
Requirements cross-reference matrix. Table IV provides a cross-reference matrix of the
section 3 requirements tested or verified in the paragraphs below.
4.6
Tests.
4.6.1 Visual inspection. The signal kit shall be visually inspected to determine compliance
with section 3 requirements in particular, this shall include the requirements of 3.2, 3.3, 3.4,
3.5.3, and 3.7.
5
For Parts Inquires call Parts Hangar, Inc (727) 493-0744
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business