MIL-DTL-10058J
accomplished using sound Analyzers, microphone System and Sound Level Meters and the pick-up
of the sound level shall be located 75 ± 0.5 feet from the simulator test fixture.
4.7.4.1.2 Non-static. The assemblies, conditioned at ambient temperature, shall be fired
by placing the assembly in an ejection machine (DWG. 9200454). The fuze igniter cord shall be
held in a fixed position. There shall be no slack evident in the igniter cord prior to initiation.
Upon ejection of the assembly, the simulator shall be initiated. The throwing range of the
ejection machine shall be not less than 45 feet and the ground shall be free of large rocks. The
assembly shall be measured and observed for compliance with the requirements specified.
Sound level intensity need not be measured during this test.
4.7.4.2 Cold temperature (-65°F ± 5°F). The simulator assemblies shall be conditioned
for 16 hours at the required cold temperature and fired within five (5) minutes after removal from
the conditioning chamber by the same method specified in 4.7.4.1.2 (Non-static). The
functioning shall be measured and observed for compliance with the requirements. If for any
reason the units are not able to be functioned within five (5) minutes, a cooler that has a
stabilized controlled temperature may be used to transport the units to the testing site for function
test.
4.8 Ammunition lot numbering. Visually verify that ammunition lot number has been
applied to each lot as described in MIL-STD-1168.
5. PACKAGING
5.1 Packaging. For acquisition purposes, the packaging requirements shall be as specified
in contract or order (see 6.2). When packaging of materiel is to be performed by DOD or in-
house personnel, these personnel need to contact the responsible packaging activity to ascertain
packaging requirements. Packaging requirements are maintained by the Inventory Control
Point's packaging activity within the Military Service or Defense Agency, or within the military
service's system command. Packaging data retrieval is available from the managing Military
Department's or Defense Agency's automated packaging files, CD-ROM products, or by
contacting the responsible packaging activity.
6. NOTES
(This section contains information of general or explanatory nature that may be helpful, but is
not mandatory.)
6.1 Intended use. The M115A2 simulator is used exclusively in training to imitate battle
sounds and flashes. It creates battle sounds and flashes mimicking that of shells in flight and
ground explosions.
6.2 Acquisition requirements. Acquisition documents should specify the following:
a. Title, number, and date of this specification, and of all reference documents
cited in Section 2, and listed in Section 6 for information.
31
For Parts Inquires call Parts Hangar, Inc (727) 493-0744
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business